
The efficiency of air conditioners and air-to-water heat pumps can be significantly reduced by frost formation under cold and humid outdoor conditions. In such situations, the equipment typically uses defrost cycles or supplementary heating systems to maintain operation. These processes may increase energy consumption and reduce overall operating efficiency.
If an alternative heat source is available, typically a gas boiler, automatically switching to it under unfavourable outdoor conditions may improve system reliability and reduce operating costs.
At first glance, switching heat sources solely according to outdoor temperature may seem straightforward, for example when the temperature falls below a configured threshold.
However, this approach may be inaccurate because:
Outdoor temperature alone therefore does not always provide a sufficiently accurate indication of frost formation risk or expected operating efficiency.
Outdoor air temperature and relative humidity together determine the dew point. The dew point provides additional information about atmospheric moisture conditions and can help assess situations in which frost formation is more likely.
Frost can form on the outdoor heat exchanger when its surface temperature falls below freezing and moisture from the surrounding air condenses or deposits on the surface. The outdoor air dew point is therefore a useful supplementary indicator, although it does not directly determine the heat exchanger surface temperature or the exact onset of icing.
DSVT allows heat source switching to be controlled according to the outdoor dew point. Compared with a fixed outdoor temperature threshold, this can provide a more representative indication of:
The objective is to make heat source selection responsive to both outdoor temperature and moisture conditions rather than relying exclusively on a fixed temperature threshold.
DSVT provides a configurable compensation value that allows the switching threshold to be adjusted to the characteristics of the installed equipment, local climate, and practical operating experience.
By adjusting this parameter, users can fine-tune when the controller switches to the alternative heat source.
The appropriate compensation setting depends on the heat pump model, outdoor heat exchanger characteristics, defrost behaviour, and the relative operating costs of the available heat sources.
The function can operate using different sources of outdoor weather information.
Supported approaches include:
Using OMSZ AROME data through the ipdns.hu service requires registration.
This allows outdoor dew point-based control to be used even in installations without a dedicated outdoor humidity sensor, provided that valid weather data is available.
Outdoor dew point-based heat source switching can be especially useful in installations where:
The function can also help fine-tune the interaction between heat sources according to the operating characteristics of the installation.
However, dew point-based switching does not guarantee lower energy costs in every situation. The actual benefit depends on heat pump efficiency, defrost frequency, the alternative heat source's efficiency, and prevailing energy prices.
DSVT outdoor dew point-based heat source switching allows the decision to operate an air conditioner or heat pump to take humidity conditions into account alongside outdoor temperature.
This provides an additional control option that can be particularly useful during weather conditions associated with outdoor heat exchanger icing.
When properly configured, dew point-based switching can support improved energy efficiency, lower operating costs, and more effective coordination between available heat sources.